Taylor 0738, Operator'S Manual

Page: 5 / 60

1
Section 1 To the Installer
To the Installer Model 0738 1-1
The following information has been included in the
manual as safety and regulatory guidelines. For
complete installation instructions, please see the
Installation Checklist.
Installer Safety
IMPORTANT! In all areas of the
world, the machine should be installed
in accordance with existing local
codes. Please contact your local authorities if you
have any questions.
Care should be taken to ensure that all basic
safety practices are followed during the
installation and servicing activities related to the
installation and service of Taylor machines.
•
Only authorized Taylor service personnel
should perform installation and repairs on the
machine.
•
Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation or
repairs.
•
Authorized service personnel must ensure
that the proper personal protective equipment
(PPE) is available and worn when required
during installation and service.
•
Authorized service personnel must remove
all metal jewelry, rings, and watches before
working on electrical equipment.
DANGER! The main power supply(s)
to the machine must be disconnected
prior to performing any repairs. Failure
to follow this instruction may result in
personal injury or death from electrical shock or
hazardous moving parts, as well as poor
performance or damage to the machine.
Note: All repairs must be performed by a Taylor
service technician.
WARNING! This machine has many
sharp edges that can cause severe injuries.
Site Preparation
Review the area where the machine will be
installed before uncrating the machine. Make sure
that all possible hazards to the user and the
machine have been addressed.
WARNING ! Only install this machine
in a location where its use and
maintenance is restricted to trained
personnel. Failure to comply may result in
personal injury.
For Indoor Use Only: This machine is designed
to operate indoors under normal ambient
temperatures of 70°F to 75°F (21°C to 24

C).
The freezer has successfully performed in high
ambient temperatures of 104°F (40°C) at
reduced capacities.
IP Code = 23
WARNING! This machine must NOT
be installed in an area where a water
jet or hose can be used. Never use a
water jet or hose to rinse or clean this machine.
Using a water jet or hose on or around this
machine may result in the electrocution of the
user or damage to the machine.
CAUTION! This machine must be
installed on a level surface to avoid the
hazard of tipping. Extreme care should
be taken in moving this machine for any reason.
Two or more persons are required to safely move
this machine. Failure to comply may result in
personal injury or machine damage. Uncrate the
machine and inspect it for damage. Report any
damage to your Taylor distributor.
Air-Cooled Units
Do not obstruct air intake and discharge openings;
a minimum 3 in. (75 mm) air space is required on
both sides and 1 in. (25 mm) at rear. This will allow
for adequate air flow across the condenser. Failure