Taylor 0738, Operator'S Manual

Page: 13 / 60

3
SAFETY
Safety Model 0738 3-3
DANGER: Hot parts, risk of burns. Hot product,
do not draw during heating treatment.
ATTENTION: Connect to a circuit protected by
fuses or HACR type circuit breaker..
ATTENTION: Only copper conductors (Cu).
Minimum section 10AWG (4mm
2
1N 230V; 4mm
2
3 230V; 2.5mm
2
3N 400V)
ATTENTION: This equipment must be properly
grounded! Failure to do so can result in severe
personal injury from electrical shock!
ATTENTION: Disconnect the power supply
before servicing the machine.
For decommissioning, comply with the standards
in force in the country where it is used
This machine is Rohs 2 compliant.
Battery type CR2032 inside. For
decommissioning, comply with the standards in
force in the country where it is used.
Water pressure limits (for water cooled models
only).
Use only R452A refrigerant that conforms to
the AHRI Standard 700 specification.
Electrical Box Warning Label
Danger: High Voltage inside; danger of
electrocution. Disconnect the Power Supply
Before Servicing the Unit.
ATTENTION: Only copper conductors (Cu).
Minimum section 10AWG (4mm
2
1N 230V; 4mm
2
3 230V; 2.5mm
2
3N 400V).
ATTENTION: Connect to a circuit protected by
fuses or HACR type circuit breaker.
To correct rotation on a three-phase machine,
interchange any two incoming power lines at the
machine main terminal block only.
Equipotential point label
Carry out an equipotential bonding, using the
screw place below the frame of the unit.
Lifting point label
Lift equipment hooking points. Position the lifting
equipment only in the relevat points.