Taylor 0738, Operator'S Manual

Page: 34 / 60

6
OPERATING PROCEDURES
6-4 Model 0738 Operating Procedures
12. Install the front drip tray bracket, rubber
drip tray, and splash shield under the door
spout.
.
Mix Pump Assembly
1. Inspect the rubber and plastic pump parts.
The O-rings must be in 100% good condition
for the pump and entire machine to operate
properly. They cannot properly serve their
intended function if nicks, cuts, or holes in the
material are present.
Inspect the plastic pump parts for cracks,
wear, and delamination of plastic.
Replace any worn, damaged, or
inoperable parts immediately.
2. Place the pump body O-ring in the groove.
3. Place the two pump O-rings into the groove
on the back of the pump body and lubricate
them.
4. Lubricate the interior surfaces of the pump
body (the rear wall , pin, and bushing).
5. Insert the drive gear on the bushing; check
that the upper face of the gear is flush with the
rim of the pump body.