Taylor-Dunn B0-248-48AC, Operation, T Roubleshooting And Replacement Parts Manual

Page: 91 / 232

Maintenance, Service, and Repair
Transmission Page 3
CHANGE OIL
6. Raise the rear of the vehicle and support with jack stands.
7. Place a four quart drain pan under the drive
assembly.
8. Remove the drain plugs from the differential case
and gear case.
9. Once the oil has drained, replace the drain plugs
and lower the vehicle to the ground.
10. Remove the fill/level plug and fill the differential up
to the bottom of the level plug opening. Refer to
the
Lube Chart
section for information regarding
type of oil.
11. Replace the fill plug.
12. Reconnect the main positive and negative cables
at the batteries.
13. Remove the blocks from the wheels.
14. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. If equipped with a hand operated park brake, set the brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.