Taylor-Dunn B0-248-48AC, Operation, T Roubleshooting And Replacement Parts Manual

Page: 27 / 232

Safety Rules Page 13
SAFETY RULES AND OPERATING INSTRUCTIONS
Model # B 2-48 / B 2-54 equipped with 30:1 drive ratio
Aceleration Parameters (normal mode)
Function Value Unit Description
FwdAS LS 2.6 S
Time to accelerate to ~15% of full
speed
FwdAc HS 4.0 S Time to accelerate to full speed
RevAc LS 8.0 S
Time to accelerate to from FwdAC LS
to full
RevAc HS 7.0 S Time to accelerate to full speed
Aceleration Parameters (low speed mode)
FwdAS LS 4.0 S
Time to accelerate to ~15% of full
speed
FwdAc HS 5.5 S Time to accelerate to full speed
RevAc LS 8.0 S
Time to accelerate to from FwdAC LS
to full
RevAc HS 7.0 S Time to accelerate to full speed
Deceleration Settings
Brake Multplier 40 %
Brake regen multiplier is activated by
the brake switch
Normal Decl HS 8.0 S
Time to decelerate to 0 when above
20% of full speed
Normal Decl LS 10.0 S
Time to decelerate when below 20%
of full speed
Tow Decl HS 8.5 S
Time to decelerate to 0 when above
20% of full speed
Tow Decl LS 8.0 S
Time to decelerate when below 20%
of full speed
Maintenance Meter Function
Service Timer 0* H
Refer to Maintenance Meter
supplementary manual
Speed Limits
Max (see warning) 6,250 RPM Governed speed (see formula)
Tow (optional) 60 %
Percentage of Max speed when Tow
Switch is ON
Rev 45 %
Percentage of Max speed when in
reverse
Low Batt 40 %
Percentage of Max speed when low
battery warning is ON
Service Due 20 %
Percentage of Max speed when
service is due. See maintenance Meter
Function
Batery Characteristics
Full Volts 2.165 V
Battery must exceed this voltage to be
considered fully charged
Empty Volts 1.730 V Voltage of a fully discharged battery
BDI Level for Batt Spd 15 %
Low battery warning is ON when
battery is discharged below this level
BDI Reset % 80 %
Battery must be discharged below this
value before the BDI will be allowed
to reset
Reset Volts 2.1 V
Battery voltage must be above this
value to reset the BDI. Modified by
the ‘BDI Reset %’ above)
Discharge Time 60 M Estimated battery discharge rate
Miscellaneous
SRO Min Speed 3,000 RPM
Motor must be below this RPM to
change directions with the throttle
pedal depressed