Taylor-Dunn B 2-48, Operation, T Roubleshooting And Replacement Parts Manual

Page: 96 / 232

Maintenance, Service, and Repair
Transmission Page 8
TRANSMISSION ASSEMBLY
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. If equipped with a hand operated park brake, set the brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Remove and Install
6. If equipped with a hand operated park brake, release the
brake and remove the park brake cables from the spring
axle mounting brackets and brake arms.
7. Disconnect the wiring from the motor.
8. Disconnect the hydraulic brake lines from the left and
right brake bodies.
12. Reinstall the drive in reverse order.
13. Bleed the brake system. Refer to
Bleed the Brake System
for information regarding
bleeding the brakes.
14. If equipped with a hand operated park brake, set the brake.
15. Lower the vehicle.
16. Reconnect the main positive and negative cables at the batteries.
17. Remove the blocks from the wheels, release the park brake and test drive the vehicle.
9. Remove the u-bolts holding the leaf springs to the
frame as shown in the illustration to the right. Do
not remove the u-bolts on the axle housing.
10. Remove the lower shock mounting bolts and the
front spring mounting bolts.
11. Raise the rear of the vehicle, lifting the frame up
and off of the drive assembly. Support the rear of
the vehicle with jack stands.