background image

SET UP

Apply hand brake, chock wheels, use jockey wheel 
to roughly level then set Stabilizer legs. Carefully 
lower rear tyre support & prepare support poles for 
rear bed. Flip & secure luggage rack (light load or 
remove load prior if weighty) - Open up each bed 
end and secure.

Inside

: Start with front / rear bed end bar and 

work from ends to middle. Fit tall centre pole to 
velcro when you have movable space inside. Avoid 
over stretching canvas. All Zippers must be closed 

before final set up to ensure easy operation. If a 
zipper is stiff - something is wrong with set up.

PACK UP

Please refer to pack up guide included with hand 
over pack. 
As above. Take care with canvas at pivot points of 
poles / camper. Ensure you have removed centre 
pole from velco tags and laid down behind cush-
ion. Make sure step is locked away prior to closing 
lid. Always lock lid latches working from roof hinge 
end to centre on both sides. Ensure spare tyre 
carrier & luggage rack are locked back in place 
with latch clips. For setup and packup, have kitch-
en and side compartments open to allow air in/out 
- easier to open/close.

POWER

Mains 240v

: Plug in your 15 amp lead (not sup-

plied) to activate all 240 volt outlets. 

NOTE: Check that the hot water system is full or un-
plugged prior to protect heating element.

*This information is based on customer questions during hand over & is simply a reminder for the initial use. Due to product de-

velopement, this may differ slightly to your purchase, so if unsure please contact your sales representative.

12 VOLT

: 2 x 100 A/H battery under seat. 50 Amp 

Anderson on draw bar is direct feed to batteries 
via 50 amp resettable fuse.  All switches have re-
set fuse standard.

Get to know power

 - 11.7 volt is flat. Damage to 

batteries by using below 12v will void warranty. 

Invest in a quality AGM / GEL stage charger 20 

amps or more & save battery life. Solar is good 
option.

PUMP & WATER TANKS

Single 12v pump with three way selector valse to 
draw water from either tank or both. 

Tanks

: Flush several times before first use. Vanilla 

essence will help eliminate initial taste. Drain if 
storing over long period or keep full in between 

use. Water filters can be purchased to go onto the 
garden hose during filling. 

Debri build up between bash plate & water tank 
can cause damage to tank.

Always turn pump off at switches when not re

-

quired.

KITCHEN

Once kitchen is opened up & support legs (under-
neath) in place there are several hoses to set up.
To use stove there is a braided gas line housed 
inside to connect into gas outlet located near 
kitchen. Under sink is a drain hose to place in 
bucket.
- Do not pour hot water down hose. There is also a 
lead for the stove light. The kitchen sink tap is a 

flick mix style with both hot & cold water lines on

Lincoln LX

MK3

BASIC INFORMATION

Reviews: