TAVRIDA ELECTRIC VCB15, Product Manual

Page: 32 / 116

32
1) Cable from electronic relay to connector block should be shielded and the case grounded near the connector. The total length of unshielded
wires from connector block to CM WAGO connector should not exceed 200 mm. Electromagnetic compatibility requirements are not
applicable for the CM USB port as this port is used only for CM programming during production and not used under service conditions.
2) Test influence is not applicable for CM “Close” and “Trip” dry contacts.
Table 14 - CM EMC Parameters
Parameter Applicable standard Rated Value
Electromagnetic Compatibility (EMC) Requirements
1)
Electrostatic discharge
IEC 60255-26
IEC 61000-4-2
8 kV contact
15 kV air
Radiated EM field Immunity
IEC 60255-26
IEC 61000-4-3
80 MHz – 3 GHz
Sweep & spot
AM 1 kHz 80% 10 V/m
Fast transient burst Immunity
IEC 60255-26
IEC62271-1
IEC 61000-4-4
4 kV common mode
Surge Immunity
IEC 60255-26
IEC 61000-4-5
4 kV common mode
2 kV differential mode
Conducted disturbance induced by Radio frequency fields
IEC 60255-26
IEC 61000-4-6
150 kHz – 80 MHz
AM 1 kHz 80% 10 V
Power Frequency Magnetic Field
IEC 60255-26
IEC 61000-4-8
100 A/m continuously
1000 A/m 1 sec
Pulse Magnetic Field IEC 61000-4-9 1000 A/m
100 kHz Damped Oscillatory Magnetic Field IEC 61000-4-10 100 A/m
1 MHz damped oscillatory magnetic field IEC 61000-4-10 100 A/m
AC Voltage Dips and Interruptions
IEC 60255-26
IEC 61000-4-11
ΔU 30% 1 period
ΔU 60% 50 periods
ΔU 100% 5 periods
ΔU 100% 50 periods
Power Frequency Disturbance Voltage
IEC 60255-26
IEC 61000-4-16
300 V common mode
150 V differential mode
2)
100 kHz and 1 MHz Damped Oscillatory Wave Immunity
IEC 60255-26
IEC 62271-1
IEC 61000-4-18
2.5 kV common mode
1 kV differential mode
Ripple on DC Power Supply
IEC 60255-26 I
IEC 61000-4-27
10% of Supply voltage,
100 Hz
DC Voltage Dips and Interruptions
IEC 60255-26
IEC 62271-100
IEC 61000-4-29
ΔU 30% 2 sec
ΔU 60% 2 sec
ΔU 100% 0,3 sec
±20 % 10 sec