VT5
22
5
TROUBLESHOOTING, CARE AND MAINTENANCE
5.1
General Instructions
⚠
WARNING
+
Do not make any improper changes to the equipment.
⚠
CAUTION
+
Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑
ATTENTION
+
In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2
Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Error
Cause
Solution
The plate does not
start
Power cable is not properly
inserted
Insert power cable
Power switch isn't switched
on
Flip power switch to on
A fuse has blownt
Contact your contract partner
The plate has stopped
moving
The standard training time of
the plate has elapsed
A new manual or automatic program
can be started.
The plate is not
reacting to the remote
control
The remote control is too far
away from the plate
Shorten the distance between the
remote control and the plate.
The plate fails to
operate properly
The plate software crashes
when receives too many
commands.
Turn of the plate at the power switch
and re-start the plate.
