Taurus T9.5, Assembly And Operating Instructions Manual

Page: 13 / 60

T9.5
13
+
E6 -
The incline motor does not run in the ADC range: The blue backlit LCD
display shows the running text ERROR 6. The window shows the running text PLEASE
RESTART AND CONTACT SERVICE (please restart the equipment and contact service if
necessary).
+
E7 -
The incline is too high or too low: The blue backlit LCD display shows the
running text ERROR 7. The window shows the running text PLEASE RESTART AND
CONTACT SERVICE (please restart the equipment and contact service if necessary).
Error E6 / E7 deviations in the incline function - simple process of elimination
If the error messages E6 or E7 are shown on the display when the treadmill is restarted,
please check the following steps:
Apply weight to the incline increase or the incline decrease in order to check the
signals of the incline motor and the communication cable. Please proceed extremely
carefully in order to avoid damage to the circuit board or the incline motor. If you
cannot apply pressure to the incline motor, please contact your contract partner.
A.
The incline angle of the treadmill is in the rise position (see image). Press STOP and
hold the button for a short time. Press the down button simultaneously. Hold both
buttons simultaneously for about three to five seconds. The incline motor forces the
treadmill to decrease the incline height. Check if the value of the incline motor (it
is located next to the error specification) changes with the incline decrease and is
adjusted to 100. If the value changes with the incline, you can release the button in
order to bring the incline position to the defined position.