Taurus T9.5, Assembly And Operating Instructions Manual

Page: 12 / 60

T9.5
12
2.3 Error codes and troubleshooting
The electronic system from the treadmill executes tests continually. If there are
deviations, an error code will be displayed and the normal operation will be stopped
for your safety.
Please contact your contract partner for technical customer service.
Error Troubleshooting
No display after turning on, Check if the power cable is correctly plugged into the eqiupment
and the outlet.
Check for the proper functionality of the outlet that you
connected the power cable to.
Check if the control cable was squished or caught during
assembly and/or the connection was lost.
Check if the safety key is correctly inserted in its holder on the
cockpit.
Check if the fault current circuit breaker popped out because of
overvoltage and press it back in if this is the case.
No or incorrect display of the heart
rate.
See “heart rate measuring” description.
Display of the error code E1 or
slight jerking while training.
The running belt and deck must be lubricated again if necessary.
If the lubrication is sufficient, then check the tension and correct
position of the running belt.
If necessary, tighten it. To do this, see “Maintenance and Care” in
these instructions.
The running belt moves again and
again despite adjustment.
Check if the treadmill is standing absolutely level. Level out any
unevenness on the ground if necessary.
The pulse hand sensors do not
work
Check if during the assembly the cables from the hand sensors
were possibly squished or clamped during the assembly.
The incline motor does not run in
the ADC range or is too high or
too low.
You can receive detailed information on the next pages.
+ E1 - The treadmill cannot read the speed value: The blue backlit LCD display shows
the running text ERROR 1. The window shows the running text PLEASE RESTART
AND CONTACT SERVICE (please restart the equipment and contact service if
necessary).