TARAL VST 818, User Instruction Manual

Page: 26 / 60

16
RULES TO AVOID TOPPLING TO THE SIDE
•
Adjust tread to maximum permitted fort he work being
performed
•
Lock pedal brakes to eachother before driving on the
road.
•
Drive at a suitable speed depending ont he land and the
work being performed.
•
Turn slowly and with big radiuses. Avoid tractor from
being swinging, you may lose steering control.
•
Do not trail heavy loads exceeding limits. Tractor may run
out of control in downwards slopes or bend around hitch
point.
•
Do not apply sudden brake, apply brakes smooth and
gradually.
•
When moving downwards slopes use engine brakes
always and use same gear as used on climbing upwards.
•
Engage 4WD, in this way you may have braked foour
wheel.
•
Do not attempt to change gear or pass through neutral
while climbing upwards slopes.
•
In high sloped areas risk of toppling while going upwards
or downwards is much more less with respect to moving
cross.
•
Do not try to pass from high sloped areas. If necessary
avoid passing through holes, sags and similar damaged
surfaces. Avoid from tree roots, bumps and elevated
zones that are especially on slope side. Keep tractor
always behind slipping line when working near by ditches
and stacks. Keep safe far from ditches, stacks,
embankments and wet zones like riversides that have risk
of collapse.
•
If it is necessary to pass from high sloped areas, do not
turn upwards to slope side, if there is no other way and
obligatory slow down and turn with a big radius as much
as possible. Pass slope directly, if possible pass upwards
or downwards but never cross. When passing upwards or
downwards always keep heavy side of tractor on upper
side of slope.
•
RULES TO AVOID TOPPLING BACKWARDS
•
Do not load 3P linkage arms. Use only and only rear hitch
to pull loads.
•
To pull from a high point may result serious injuries or
even death. Apply loads only on trailer hitch.
•
Use front weights to balance tractor when carrying heavy
loads.
•
When moving forward and increase speed gradually. Do
not increase engine speed too much and do not dis-
engage clutch. If tractor is connected with a heavy load or
stationary object improper use of clutch may result
toppling of tractor.
•
If front side of tractor ramps up, slow down and disengage
clutch if necessary.
•
If tractor stcuks in mud or sticks to ground do not try to
move forward. Elevate equipment if exists and move
backwards. If not possible puyll with another tractor.
•
If you stuck in a ditch if possible move backwards. If you
move forwards go slowly and carefully.
•
If stucked in a ditch you can go forward slowly if in case
equipments located opposite side of slope.
•
When driving upwards keep tractor on gear always, do not
try to drive in neutral or clutch dis-engaged.
•
To shift gear, proper gear selection and start movement
chose flat surfaces. Do not change gear while climbing or
descending slopes, keep on moving, if necessary re
arrange on a flat area.
•
Chose flat areas to park tractor.