User guide
The Menu
78
Increasing the print head gap
(Head up)
With this function you can increase the print head gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting: Off
If the parameter is set to On, the print head gap increases during
form feed and line feed four lines before and after the perforation on
the form (= protected zone). The print head gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
Printing is possible in the protected area.
Confirm the setting by pressing the Set (1) key.
Paper width (Pagewid)
This parameter determines the actual paper width.
Press the Pagewid key (3).
Setting options: From 20 to 136 in 1/10 inch steps
Default setting: 136/10 Zoll (136 characters at 10 characters/inch)
If Head up = On, the print head moves to the calculated center of
the paper during the time the paper is moving in the protected zone.
If Rightzo = On (see below), the print head moves out of the perfo-
ration zone on the right as long as the paper is being transported.
Set the printing width rather than the actual paper width.
Confirm your settings with the Set key (1) and press the Next key
(4) to access the next group of parameters.
Head up=Off *
Online
Setup
Set < > Exit
2
1
3
4
1
2
2
3
4
5
6
7
8
1
Top edge of form
5
Protected zone
2
Paper transport strip
6
Transport holes
3
Bottom edge of form
7
Left-hand area
4
Form separation perforation
8
Right-hand area
Head up Pagewid
Online
Setup
Back
Next
2
1
3
4
Pagewid=136/10“*
Online
Setup
Set
<
>
Exit
2
1
3
4