TallyGenicom 9040, User Manual

Page: 37 / 152

User Guide 3-11
Operator Panel Menus
Operator Panel
Format Raw
Normal
Binary Raw Configures how incoming print jobs are
scanned for special binary control codes.
RAW=no processing
Normal = “Adobe Standard Protocol” (ASP)
Binary = “Binary Control Protocol” (BCP)
When Interpreter setting is Auto Switch and
this setting is Raw, the printer will
automatically determine the control code
method, defaulting to Normal if no codes are
found.
Network Address <hex display
of MAC
address> NA Displays MAC address of network interface.
IP Address data entry 000.000.000.000 IP Address. If DHCP is enabled, this is
read-only. Otherwise, this can be changed by
the address can be set manually here
Subnet Mask data entry 000.000.000.000
Default Gateway data entry 000.000.000.000
LPD Banner On/Off Off If ON, prints a special “banner page” before
each LPR print job.
DHCP On/Off On
IPv6 On/Off Off
Delay Out Close On/Off Off When ON, the printer will wait until the job
is completely printed and delivered to the
output tray before terminating the
connection, allowing all reverse-channel
data to be sent back to the host. This will
cause a reduction in printer throughput.
When OFF, reverse-channel data generated
after the job interpretation is discarded. No
reduction in printer throughput occurs.
mDNS On/Off On Enabled multicast-DNS protocol. mDNS is
the underlying protocol for “Bonjour”.
Local Link read-only 000.000.000.000 Auto-negotiated “local link” internet address
(used primarily by Bonjour protocol)
Multi-Session On/Off Off When On, allows the printer to have
multiple network print sessions open at a
time. When Off, only 1 session can be
opened at a time. Some server environments
may benefit from a setting of Off.
EtherTalk On/Off On
Netware Setup This submenu allows you to set up the
Netware interface.
Netware On/Off Off
Menu Item Value Default Description