TallyGenicom 6300 Series, Maintenance Manual

Page: 74 / 175

6300 Series Maintenance Manual
68
4.12 Installing the Platen Motor and Sensor PCA
1. With the assembly in-hand, turn the motor shaft so that it is aligned as in the
“pictogram” just to
the left of the shaft.
2. Insert the assembly through the side frame of the printer and install and tighten the
mounting screws.
3. Reach through the opening at the back of the side frame and move the platen to a
“full open” position.
4. Holding the platen fully open and ensuring the motor shaft is still aligned, tighten the
set-screw that mounts the platen to the motor shaft.
5. Connect the cables.
6.
Power the printer up then run the “Platen” function (Engine Cal –
Platen) which
calibrates the platen sensor to the platen motor. You can monitor the progress on the
display of the printer.