TallyGenicom 6300 Series, Maintenance Manual

Page: 39 / 175

Chapter 2. Menu Operations
33
2.3.3.5 Ribbon Speed
Provides a means to vary the Ribbon Motor speed for a Ribbon Motor Test.
Speed selections: 1
–
250, Default.
2.3.3.6 Paper Out Thold
This parameter allows you to set the Paper Out Threshold value for the Paper Out Sensor. By
using this, you can compensate for the reflectivity of different types of paper.
Selections are 1- 255.
2.3.3.7 Clear
This parameter provides you with a means of clearing portions of NVRAM to factory default
settings.
2.3.3.7.1 Counts
Clears the count information from NVRAM, and clears the Fault Log.
2.3.3.7.2 Calibrations
Clears the calibration data from NVRAM. When CalData is selected you must perform Hammer
and Paper Calibration routines before using the printer.
2.3.3.7.3 NVRAM
Clears the application configuration portion of NVRAM.
2.3.3.8 Shuttle Off
This parameter allows you to set the amount of time the shuttle remains at speed after the last
printed data.
Options are 10 Sec, 20 Sec, 30 Sec, and 60 Sec.
2.3.3.9 Serial Dump
When this parameter is enabled, the data the printer receives from the parallel port of PSIO cards
is replicated and sent out from the serial port. This allows you to connect a serial cable from the
printer to a computer and capture the data using a serial capture utility.
2.3.3.10 Serial Number
This parameter provides for the entry of a unique printer serial number. Each digit is entered in the
same manner as that used to enter a configuration name.