TALARIA POWER TECH (CHONGQING) CO., LTD.
XI. Maintenance Service
— 44 —
Keep the disc brake system clean in daily use to avoid sand accumulation for a long time, especially oil stain.
Inspection for operating parts
Check the shock absorber
for any bending, deformation, damage, looseness, oil leakage and other faults. Shake the
handlebar up and down to check for any abnormal sound caused by foreshock fault.
Brake inspection:
1. Check whether the free clearance of the brake lever is within the specified range (15-30mm). If the measured result does
not meet the requirements, it shall be adjusted.
2. When driving at low speed on a dry and flat road, use the front and rear brakes respectively to check their braking
function.
Inspection for tire and other parts:
1. When the tire is cool, check the air pressure with a tire barometer.
2. Check for any cracks, damages, foreign matters and abnormal wear.
3. Check whether the rim spokes are loose.
4. Check the tension of the chain. It should be 10–20mm from the top and bottom of the chain.
Stones, glass, nails and other foreign matters on the ground will damage your tire as it is in long-term contact with the
ground. Therefore, when riding, make sure to observe the road surface to avoid the places where the tire may be damaged.
In addition, regularly check the tire for any obvious cracking and other damage, whether it has been penetrated by stones,
glass and other foreign matters, and whether there is abnormal wear.
Inspection for tire tread depth
Check the tire wear and the tread depth. Replace the tire 2/3 of the tread are worn off. When the tire makes abnormal
44
