TALARIA STING R L1E, Owner'S Manual

Page: 42 / 53

TALARIA POWER TECH
Maintaining Your Motorcycle
Any issues found through the inspection should be eliminated before you ride the motorcycle. If it is difficult to solve it by yourself, please send the
motorcycle to the nearest dealer for service.
CAUTION:
The front and rear brakes are disc brakes. If the brake pads are severely worn, shall replace them in time.
Keep the disc brake system clean in daily use to avoid sand accumulation for a long time, especially oil stain.
Parts/Maintenance Items
Front Fork Inspection:
Check the front fork for any bending, deformation, damages, looseness, oil leakage and other faults. Press the handlebar up
and down to check for any abnormal sounds caused by front fork fault.
Brake Inspection:
1. Check whether the free clearance of the brake lever is within the specified range (15-30mm). If the measured result does not meet the requirement,
it shall be adjusted.
2. When driving at low speed on a dry and flat road, use the front and rear brakes respectively to check whether the brakes work correctly.
Inspection For Tire and Other Parts:
1. Inspect the air pressure with a tire barometer when the tire is in normal temperature status.
2. Inspect the tire for any cracks, damages, foreign matters and abnormal wears.
3. Inspect whether the spokes are loose.
4. Inspect the tension of the chain. The chain should move 10-25mm for free play.
Caution: Stones, glass, nails and other foreign matters on the ground will easily damage the tire as tire contact with the ground for a long-term. When
riding, make sure to observe the road surface to avoid the places where the tire may be damaged. In addition, regularly check the tire for any obvious
cracks and other damages, whether it has been penetrated by stones, glass and other foreign matters, and whether there are abnormal wears.
Inspection For Tire Tread Depth:
Check the tire wear and the tread depth. Replace the tire if 2/3 of the tread are worn off. When the tire makes abnormal noise and swings during
riding, please send the motorcycle to the nearest dealer for inspection and maintenance. It is recommended to set the locking torque of the rear fork