Takeuchi TB225, Operator'S Manual

Page: 203 / 297

5-37
MAINTENANCE
4. Remove the cap (A), install connector (B)
and drain the oil. (The oil comes out when
the screw is tightened.)
5. Remove the connector (B) and install the
cap (A).
IMPORTANT: Check the waste oil for
metal powder. If it contains large amounts
of metal powder, consult your sales or
service dealer.
6. Turn the filter (4) counterclockwise with the
filter wrench and remove it.
7. Clean the surface of installation of the filter
stand.
8. Apply a thin layer of oil on the packing of
the new filter.
9. Install the new filter by hand.
10. Tighten one more turn (with the filter
wrench) after the filter packing comes in
contact with the surface of installation.
(Torque when tightening with filter
wrench: 19.6 to 23.5 N·m or14 to 17
ft-lb)
11. Add oil up to between the upper limit (H)
and the lower limit (L) of the dipstick (1).
Problems could arise if the oil level is
either too low or too high.
12. Tighten the oil filler cap (2).
13. Start the engine, run it at low idle for
about 5 minutes, then stop it.
14. After about 10 minutes, inspect the oil
level.
EVERY 250 HOURS