20
WARNING
Check before operating the product:
Daily Inspection Procedure
Be sure to observe daily inspection according to the following guidelines. Continued use without observing the
daily inspection may result in failure or accidents.
To use the product safely, be sure to observe the following inspections.
■Daily Inspection Items (Pre‑Operation Check)
Inspection Item
Inspection Procedures
If the inspection results show defects:
□Check if there is no deformation,
breakage, or deterioration on the
power plug or the power cord of
the dryer arm.
□There is no deformation breakage or
deterioration on the power plug or
the power cord.
Check while the product is in operation. (this
is limited to the case that there is no
deformation breakage or deterioration on
the power plug or the power cord)
□The power plug or the power cord may
be heated when it is deteriorated.
While the product is in use, touch the power
plug and the power cord with a hand and
make sure that they are not hot.
□Check if there is no breakage
or deterioration on exterior parts.
Visually check the entire product and
check for any breakage or deterioration
of the exterior parts, etc.
□Check that the power switch
operates properly and the
lamps on the control panel
illuminate.
Check if there is no jamming when turning
ON/OFF the power switch. In addition, check
that all of the lamps illuminate right after
turning on the power switch.
□Make sure that the wall mount
bracket does not wobble.
Move the product attached to the dryer arm
and check the action.
If you note problems such as the wall mount
bracket is swinging from at its base on the
wall, disconnect the power plug and
immediately contact the nearest dealer or
Takara Belmont directly.
There is a possibility of electrical shock or
burn injuries due to fire or electrical
leakage. Since some parts must be replaced,
immediately stop using the product, turn off
the power switch, disconnect the power
plug, and immediately contact the nearest
dealer or Takara Belmont directly.
Restrictions in bringing out the expected
functions of the product may result in
accidents (injuries including burns).
Immediately stop using the product, turn off
the power switch, disconnect the power
plug, and immediately contact the nearest
dealer or Takara Belmont directly.
If the product is used with the power
switch functioning improperly, failures such
as unexpected shutdown of power during
operation may occur. Furthermore, in the
state that the lamps on the control panel do
not illuminate, the product may not be used
correctly because the setting state cannot be
confirmed. If this is the case, immediately
stop using the product, turn off the power
switch, disconnect the power plug, and
immediately contact the nearest dealer or
Takara Belmont directly.
□Make sure that the devices attached
to the dryer arm are not loose.
□Make sure that the dryer arm
operates safely without any problem.
Move the product attached to the dryer arm
and check the action.
Move the product attached to the dryer arm
and check the action.
If you note problems such as the device is
swinging from at the joint part with
the dryer arm, disconnect the power plug
and immediately contact the nearest dealer
or Takara Belmont directly.
If you note any problem, disconnect the
power plug and immediately contact the
nearest dealer or Takara Belmont directly.
