10
E r r o r C o d e s
‑ If an error code appears on the display panel, take adequate action according to the following table.
Symptom
Actions to be Taken
Indication
The code
and the current
remaining time
indication will
blink, alternately.
The code
and the
current remaining
time indication will
blink, alternately.
The code
blinks.
The code
blinks.
After operating for three minutes or
longer, the surface of the customer s
head is hotter than the preset
temperature.
The surface of the customer s head
is not warm at all.
The customer s head has moved
from the current position, or the
temperature of the surface of the
head has decreased.
The ring movements are abnormal.
The surface of the cutomer s head
is too hot.
Check if the customer's head position is set too far from the heater.
If it is, reset it at the correct position. (See page 11.) If the position
is correctly set, check that the sensor sheet is clean. If the sheet is
not clean due to agents etc., wipe it off completely. Turn off the
power, then on again and use it with the head set at the correct
position. If the condition does not change after taking this action,
contact the nearest dealer or Takara Belmont directly.
Contact the nearest dealer or Takara Belmont directly.
Check the position of the customer's head. Keep the product
running. After a while, the error will be cancelled when the
customer's head temperature reaches the setting temperature.
Turn off the power and then on again. If the error condition
continues, contact the nearest dealer or Takara Belmont
directly.
Contact the nearest dealer or Takara Belmont directly.
