16
START/STOP
PERM
COLOR
TREATMENT
MANUAL
TEMP
TIME
ROTATE
×
○
○
○
○
○
○
×
○
×
×
○
○
○
×
×
○
○
○
○
×
○
○
○
×
×
○
×
×
×
×
○
○
○
○
×
FRONT
SIDE
NAPE
×
○
○
○
×
×
Manual only
Manual only
Selected mode
Lamp Indication During Operation and Inputs from Button
Note: Items marked with the "○" accepts input from buttons, while items marked with the "×" do not accept input from buttons.
Note: The elapsed time after finishing the operation (cooling time) will be counted up to 60 minutes. Press the START/STOP
button to reset the conditions to those at the time of START.
Mode and Operation
Power ON
Before
Operation
Completion
During
Operation
During
Interruption
Cooling
Lamp
Indication
Button Input
Lamp
Indication
Button Input
Lamp
Indication
Button Input
Lamp
Indication
Button Input
Lamp
Indication
Button Input
Lamp
Indication
Button Input
O F F
O F F
O N
O N
O N
O N
O N
O N
O N
O N
Count down
Count up
O F F
O N
Count down
FAN
※Option
Selected mode
O N
O N
O N
O N
O N
O N
O N
O N
O N
O F F
O F F
O N
O N
O F F
O N
Manual only
Selected mode
Selected mode
O N
1 sec ON
→ OFF
1 sec ON
→ Blink
1 sec ON
→ OFF
1 sec ON
→ OFF
1 sec ON
→ OFF
1 sec ON
→ OFF
Blink
Blink
Blink
Blink
Blink
Blink
Blink
1 sec
→ OFF
Customized Settings
It is possible to adjust the initial settings in each mode as required. (customized settings)
(The initial settings are displayed when the mode selection button is pressed.)
The customized settings are stored in memory even after turning off the power.
This procedure restores the default settings (factory settings).
(Factory setup: see page 9)
1. Select the mode selection button in which you would like to customize the settings.
2. Change the setting for temperature, time, or heating position.
3. Keep pressing the mode button for one second or longer. An electronic beep sound will be heard,
and the new settings are stored.
4. Release the finger from the mode button. The new settings are now stored.
5. Turn off the power, and then on again. Check that the settings are correct.
1. Turn on the power while pressing the Start/Stop button.
2. An alarm sound will be heard after one second, and the mode settings are restored to the default settings.
3. Release the finger from the Start/Stop button, and the procedure is completed. Check the settings.
1. Customizing Settings in Modes
2. Reverting to the Default Settings
*During the operation or interrupted operation, the settings will not remain in memory.
