Tainet ITM-3296bis, User Manual

Page: 59 / 131

3-34 FRONT PANEL LCD AND MENU-DRIVEN
ç
NORMAL AT%D0 /Same as V.25 108.2 DTR operation (default).
ç
AUTO DIAL/ANS AT%D1 /Same as V.25/V.25bis 108.1 DTR operation.
When DTR is from OFF to ON,the modems will
dial ( see DIAL MENU-AUTO dial tel# ) and
answer ( Note the ring times in dial manu must be
set to AUTO ANS OFF).
DTR OFF ACTION AT&Dn On originate and answer site respectively modem
action select for DTR from ON to OFF.
ç
FORCE ON AT&D0 /Force DTR in ON position (default).
A power-on auto dial operation can be achieved
when operating with DTR ON auto dial.
ç
COMMAND MODE AT&D1 /Return to command mode.
ç
DISCONNECT AT&D2 /Disconnect. Normally used with 108.1.
ç
MODEM RESET AT&D3 /For Modem reset.
DSR CONTROL AT&Sn DSR signal control selection.
ç
NORMAL AT&S1 /DSR ON after Modem handshaking.
ç
FORCED ON AT&S0 /Force DSR in ON position.
DCD CONTROL AT&Cn DCD signal control selection.
ç
FORCE ON AT&C0 /Forece DCD in ON position.
ç
NORMAL AT&C1 /DCD ON means line is in connection while DCD
OFF means line is OFF.
ç
V.13 HDX AT&C2 /CCITT V.13 standard simulated carrier in half-
duplex.
ç
PSEUDO HDX AT&C3 /When data continuously receive all one's more
than 24 bits or when line is disconnected, drop
DCD to operate as simulated HDX control
carrier.This is normally used in IBM SNA Polling
networks.
RTS CONTROL AT&Rn RTS signal control selection.
ç
NORMAL AT&R0 /Controlled by DTE.
ç
FORCED ON AT&R1 /Keep RTS in ON position.
RTS/CTS DELAY ATS26=n Delay time from RTS-ON to CTS-ON. Usually
used in cascade application (default=0).
ç
0..2550 ms (bit0..7) /0-2.5 seconds.