Tainet ITM-3296bis, User Manual

Page: 46 / 131

FRONT PANEL LCD AND MENU-DRIVEN 3-21
SEND ADP./ODP.
ç
OFF
ç
ON
ATS40=n
(bit3)
During the process of V.42 protocol
identification,a special fixed signal will be
identified if V.42 protocol can be provided. But
if the user be sure that the modem of both sides
use or not use V.42, he may set to OFF so as to
speed up the line connection. (default is ON).
SIM. ENQ. AT\Hn Emulate ENQ/ACK in DTE pacing, normally
used for the connection of HP Host and
terminals. This function can be used together with
DTE flow control or used alone.
ç
NONE AT\H0 /(default).
ç
SIM. PERIPHRAL AT\H1 /Use in connection with HP Host.
ç
SIM. HOST AT\H2 /Used in connection with HP terminal.
DISCON. METHOD ATS40=n Disconnect method for V.32/V.32bis/V.34.
ç
IMMEDIATE (bit2) /Immediate disconnect.
ç
WITH CLEAR-DOWN /Send clear down before disconnection.
DCD-DCE FLOW AT\Gn To activate DCE-DCE flow control or not in
normal mode.
ç
OFF AT\G0 /Disable. Normally, DCE-DCE flow control is
not necessary unless DTE speed < modem speed
(default).
ç
ON AT\G1 /Enable.
DCE INACTIVE
ç
FOREVER
ç
1..7 MINUTES
ATS43=n
(bit2...0)
Under V.42/MNP operation, if the dataflow is
interrupted by any reason caused by DCE with
duration longer than this set time period,
modem will give up V.42/MNP and return to
direct mode.(default = 1 minute).
RESEND TIMES
ç
FOREVER
ç
12..180 TIMES
ATS42=n
(bit3...0)
For a single block, modem will give up
V.42/MNP and retrun to direct mode when
resending times is more than this setting caused
by any reasons. (default = forever).
FAST RESET
ç
NORMAL ATZ,AT&F
ç
FAST ATZ
ç
FAST AT&F
ç
FAST ATZ,AT&F
ATS32=n
(bit0,1)
Reset rate selection for ATZ and AT&F
/(default)