Tahoe TI9000LXU, Operation Instructions And Parts Manual

Page: 27 / 34

- 25 -
UNPACKING
This product requires assembly.
■
Remove one end of the box and carefully slide out the
generator and any accessories.
NOTE: The generator is heavy. If you must lift the unit out of the
box, get another person to help you and lift with your legs, not
your back.
■
Inspect the unit carefully to make sure no damage occurred
during shipping.
■
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
INSTALLING THE WHEELS
See Figure 1.
Wheel are provided to assist in moving the generator to the desired
location and should be installed on the side opposite the recoil
starten.
NOTE: Install the wheels before installing the handle. Do not put
fuel or oil in the generator before installing the wheels.
■
Locate the following items:
2 wheel axles 2 wheels
2 small cotter pins 2 large cotter pins
■
Raise the end of the
generator opposite the recoil
starter high enough to gain
access to the frame bottom;
securely
position props
underneath to support.
■
Locate the U-bracket on one
side of the frame bottom.
Slide a wheel axle through
the bracket so that an end
extends from both sides of
the bracket.
■
On the end that extends
inside the generator frame,
insert a small cotter pin
through the hole in the axle
to secure.
Bend the ends of the cotter pin to prevent the pin from slipping
out.
■
Place a wheel over the other end of the axle.