7
Vacuum Hose Attachment
Latch Assembly
Recovery Tank Drain
Filling the unit for use as an extractor
• Unplug the unit.
• Disconnect the solution and recovery tanks.
• Remove the upper recovery tank.
• Add water and/or chemicals to the lower solution tank. Fill only to the fill line indicated on
the label on the inside of the solution tank. The tank will hold up to 3.5 gallons.
Operating the extractor
• Attach the solution line from the vacuum hose assembly to the quick disconnect in the
pocket at the front of the machine.
• Attach the vacuum hose to the vacuum inlet (handle) above the recovery tank lid.
• Turn the 3-way switch to VAC PUMP. (Allow approximately 30 seconds for the pump to
prime).
• Attach the hand tool to the hose end. Use the hand tool to spray and recover the solution.
• The float shut-off will disable the suction of the unit when the recovery tank is full. The
operator will notice a distinctive change in the sound of the vacuum motor when the shut-off
is activated. Empty the recovery tank and then fill the solution tank to resume cleaning.
Emptying the Recovery Tank
• Unplug the unit.
• Disconnect the solution line and vacuum hose.
• Unlatch the recovery tank from the base of the unit and remove.
• Remove the drain plug.
• Drain the tank over a suitable outlet for wastewater.
• Rinse the tanks after each use.
• Store the unit with the lid off of the recovery and allow it to air dry.
Spray Tip (included
both an atomizer
and fan spray tip)
Wand Hose
Wand
Extractor
Hose
Assembly
EXTRACTOR OPERATING INSTRUCTIONS
