Taarup 7640, Operator'S Manual

Page: 56 / 72

56
Operator´s manual round bale wrapper 7640
10.9.5 Sensor timeout loading arm (5)
Top value (In:) indicates the time which the cylinder remains
activated for closing loading arm after sensor is detected.
Bottom value (Out:) indicates the time which the cylinder remains
activated for opening loading arm after sensor is detected.
10.9.6 Table timing (6)
In this screen the timing for the table down state can be configu-
red. This time should be set to a value, which allows the bale to
be dropped onto the field properly before going back to horizontal
position again. The time can be programmed in steps of 0.1 sec.
10.9.7 Film cutter setup (7)
In this screen the parameters for the film cutter can be configured.
The first film release (Tf) time can be programmed in steps of 0.1
sec and is the time the cutting device has to go up during the film
release state.
The second film release (2f) can be programmed to occur after X
wi Y parts of the final lap.
The sensor (Ts) time can be programmed in steps of 0.1 sec and
is the extra time the film cutter has to continue after the up or
down sensor has been detected.
10.9.8 Rollers/satellite reverse speed (8)
When the satellite valve is reversed manually the speed, which is
programmed here is used. 2.0s is the time table rollers are rever-
sed in a case of monitored film break.
10.9.9 Not in use (9)
Screen 9 is not displayed
10.9.10 Not in use (10)
Screen 10 is not displayed
10.9.11 Not in use (11)
Screen 11 is not displayed
10.9.12 Not in use (12)
Screen 12 is not displayed
10.9.13 Sensitivity of safety arm (13)
This parameter gives access to adjustment of safety arm’s sensiti-
vity. Value 1 x 50 ms means that circuit may remain open for this
period before machine stops
Operating model C