44
Operator´s manual round bale wrapper 7640
10.4.1.7 Enter/OK switch
In process mode:
1.
Starts the next process sequence if Manual mode is selected.
2.
When an automatic cycle has been interrupted by the stop key,
the system will go the idle mode. When restarted entering the pro-
cess mode again, the light next to the Enter switch will flash to indi-
cate that the interrupted cycle can be continued by selecting this
switch. Entering Tool mode will quit this ‘OK to continue’ function.
3.
PIA mode
Activates the chosen function
4.
Tool mode
In Tool mode activating this switch will start a ‘Finish wrap cycle’.
This is a useful function when machine has been operated by the
manual keys, since it is difficult to do cutting and positioning of the
prestretchers simultaneously.
Edit mode:
The key is used as an ‘Enter’ key to confirm the edited value and to
quit editing of the current field. When there is a next edit field, the
edit mode will continue with the next parameter.
10.4.1.8 Jo/up
Process Mode in Auto or Manual::
Table up
PIA mode
Selection of function to operate
Tool mode:
Depending on selected joystick function group.
Edit mode:
The plus switch will increase the edited value by the pre-pro-
grammed step value (usually 1). When the switch remains active the
value will continue to increase using a larger step size.
10.4.1.9 Joystick –/down
Process Mode in Auto or Manual:
Table down
PIA mode
Selection of function to operate
Tool mode:
Depending on selected joystick function group.
Edit mode:
The minus switch will decrease the edited value by the pre-program-
med step value (usually 1). When the switch remains pressed the
value will continue to decrease using a using a larger step size.
Operating model C
Summary of Contents for 7640
Page 2: ...2 Operator s manual round bale wrapper 7640...
Page 13: ...13...
Page 39: ...39 Operating model S...
Page 71: ...71 Notes 13 Notes...
