Taarup 7640, Operator'S Manual

Page: 36 / 72

36
Operator´s manual round bale wrapper 7640
9.5.2 Cycle [Cyk]
When the function [Cyk] is activated, two digits are
displayed.
The left digit shows the actual no. of sensor passes.
The right digit shows the programmed no. of sensor
passes.
No. of sensor passes depends on bale size and desired
no. of film layers. Ref. chapter 7.3. No. of sensor passes
can be set from 2 til 99.
When actual sensor passes has the same value as
programmed sensor passes, a red diode will flash to
indicate that the wrapping is ready.
Example: Programming 6 layers of film and 120cm bale diameter = 24 sensor passes.
Press key Display shows Explanation
F2 0 12 Cycle «Actual sensor passes» and «programmed sensor passes»
F1 12 Press the key until the digit flashes
F3 22 Press F3 until the first digit is 2
F1 22 Press F1 to select the last digit
F3 24 Press F3 until the last digit is 4
F2 Press F2 to store the value and exit programming cycle.
The stop position of the satellite for film cutting is
adjustable to accommodate to oil flow and bale size to
ensure optimum functionality of the film cutter.
The value is to be set so the film cutter can catch, hold and
cut the film without damaging the film. The value can be
set from 0 00 to 1 99.
The value 0 00 will stop the satellite immediately after the
sensor is activated. The adjustment of the value is done in
the same way as adjusting the cycle. Ref. 9.5.2.
Example: Programming factor 0 56.
9.5.3 Satellite stop position [F.]
Press key Display shows Explanation
F2 1 20 Cycle «Satellite stop position»
F1 z zz Press the key until the digit flashes
F3 0 zz Press F3 until the first digit is correct
F1 0 zz Press F1 to select the next digit
F3 0 5z Press F3 until digit no. 2 is correct
F1 0 5z Press F1 to select the last digit
F3 0 56 Press F3 until the last digit is correct
F2 Press F2 to store the value and exit programming cycle.
Operating model S