Sysmac OMRON NA Series, User Manual

Page: 161 / 182

5 - 15
5 Troubleshooting
NA-series Programmable Terminal Hardware User’s Manual (V117)
5-
2 T
rou
blesh
oot
ing
5
5-
2-5 T
roubleshooting NA Unit Err
ors
E_SYS_015: The bat-
tery voltage is low. The battery voltage fell
below a certain level dur-
ing operation. Replace the battery following the procedure given in
6-2 Replacing the Battery on page 6-5
E_SYS_019: XXX must
be behind XXX. The filtering conditions for
the Alarm Viewer were
mistakenly specified. Check the set values of the EndTime and StartTime
parameters and the filtering conditions in the FilterBy-
DateTime function.
E_LOG_001: Backup
to MRAM has failed for
XXX The M-RAM cannot be
written normally. Restart the NA Unit. If the same message is displayed
after the restart, execute system recovery. If the same
message is displayed even after system recovery, the
NA Unit must be repaired. Inquire at the contact given
on the back of this manual.
E_LOG_002: Failed to
recover data from
MRAM for XXX. All the
data within MRAM
have been cleared. The XXX data on the
M-RAM is in an illegal
state.
E_LOG_003: Failed to
backup Alarms to
MRAM. The M-RAM cannot be
written normally.
E_LOG_004: Failed to
recover Alarms from
MRAM. All the data
within MRAM have
been cleared. The alarm data on the
M-RAM is in an illegal
state.
E_LOG_005: Failed to
write XXX records to
file: XXX Logging the data failed. • Insert an SD Memory Card or USB Memory Device
into the NA Unit.
• Replace the SD Memory Card or USB Memory
Device with one with sufficient available space.
If the same message is displayed even if you perform
the above corrections, try replacing the SD Memory
Card or USB Memory Device.
E_LOG_007: Failed to
create log file for XXX
E_LOG_006: Logging
for XXX has been
stopped Initialization for data log-
ging failed. Restart the NA Unit. If the same message is displayed
after the restart, execute system recovery. If the same
message is displayed even after system recovery, the
NA Unit must be repaired. Inquire at the contact given
on the back of this manual.
E_MED_001: The for-
mat of the video file
XXX used in XXX is not
supported. The video file has an
unsupported format or is
in an illegal state. Convert the file to a supported format and download
the data again.
E_MED_003: Failed to
play the video
(0xXXXXXXXX).
E_MED_004: Failed to
pause the video
(0xXXXXXXXX).
E_MED_005: Failed to
stop the video
(0xXXXXXXXX).
E_MED_006: Unex-
pected error in media
player XXX.
E_MED_007: Failed to
initialise the media
player. Check if the
video file exists and its
format is supported.
Output message Cause Correction