Synrad Novanta OEM ti Series, User Manual

Page: 30 / 106

FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS PAGE | 30
Federal Communications Commission (FCC) Requirements
The United States Communication Act of 1934 vested the Federal Communications Commission (FCC)
with the authority to regulate equipment that emits electromagnetic radiation in the radio frequency
spectrum. The purpose of the Communication Act is to prevent harmful electromagnetic interference
(EMI) from affecting authorized radio communication services. The FCC regulations that govern
industrial, scientific, and medical (ISM) equipment are fully described in 47 CFR, Part 18, Subpart C.
NOVANTA© ti Series lasers have been tested and found to comply by demonstrating performance
characteristics that have met or exceeded the requirements of 47 CFR, Part 18, Radiated and Conducted
Emissions.
Important Note: The following FCC information to the user is provided to comply with the
requirements of 47 CFR, Part 18, Section 213.
FCC information to the user Interference Potential
In our testing, NOVANTA, has not discovered any significant electrical interference traceable to ti Series
lasers.
System Maintenance
Ensure that all exterior covers are properly fastened in position.
Measures to Correct Interference
If you suspect that your laser interferes with other equipment, take the following steps to minimize this
interference:
1 Use shielded cables to and from the equipment that is experiencing interference problems.
2 Ensure that the laser is properly grounded to the same electrical potential as the equipment or
system it is connected to.
FCC caution to the user
The Federal Communications Commission warns the user that changes, or modifications of the unit not
expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
European Union (EU) requirements
RoHS compliance
NOVANTA ti-Series lasers meet the requirements of the European Parliament and Council Directive
2014/65/EU on the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment that establishes maximum concentration values for certain hazardous substances in electrical
and electronic equipment.