Synrad Novanta OEM ti Series, User Manual

Page: 19 / 106

TI-SERIES WATER-COOLED REAR PANEL PAGE | 19
Figure 2-2 ti-Series Rear panel controls and indicators. (Water-cooled ti100 shown).
ti-Series water-cooled rear panel
DC Power Cables – Re48 VDC from the DC power supply. Ti-Series DC power cables are
manufactured from #10 AWG wire and measure 1 meter (42 inches) in length.
INT (Remote Interlock) Indicator – Illuminates green to indicate that a remote interlock circuit is closed
and that lasing may be enabled (on Keyswitch lasers, a five-second delay occurs when the interlock
circuit closes). The INT indicator is red, and lasing is disabled if the interlock input is open.
TMP (Temperature) Indicator – Illuminates green to indicate that laser temperature is within limits and
that lasing may be enabled. The TMP indicator is red, and lasing is disabled if the laser’s temperature
rises above safe operating limits.
RDY (Ready) Indicator – Illuminates yellow when the laser is enabled, indicating that, after a five-second
delay, lasing will begin when a PWM Command signal is applied.
SHT (Shutter) Indicator – Illuminates blue to indicate that a Shutter Open Request signal is connected
to the User I/O port and lasing may be enabled. On Keyswitch lasers, a five-second delay occurs when a
Shutter Open Request signal is applied.
LASE Indicator – Illuminates red to indicate that the laser is actively lasing. The LASE indicator is off
when tickle pulses are being generated and illuminates red when PWM Command signal pulses are long
enough to produce laser output.