Synrad FH FLYER, Operator'S Manual

Page: 64 / 250

Laser Safety
components to ensure that they meet all applicable local laser safety requirements. In cases
where the Buyer is also the end-user of the OEM laser product, the Buyer/end-user must inte-
grate the laser so that it complies with all applicable laser safety standards as set forth above.
Federal Communications Commission (FCC)
requirements
The United States Communication Act of 1934 vested the Federal Communications Commis-
sion (FCC) with the authority to regulate equipment that emits electromagnetic radiation in
the radio frequency spectrum. The purpose of the Communication Act is to prevent harmful
electromagnetic interference (EMI) from affecting authorized radio communication services.
The FCC regulations that govern industrial, scientific, and medical (ISM) equipment are fully
described in 47 CFR, §18, §§C.
SYNRAD
®
laser lasers have been tested and found to comply by demonstrating performance
characteristics that have met or exceeded the requirements of 47 CFR, §18, Radiated and
Conducted Emissions.
FCC information to the user
Interference Potential
In our testing, SYNRAD has not discovered any significant electrical interference traceable to
laser lasers.
System Maintenance
Ensure that all exterior covers are properly fastened in position.
Measures to Correct Interference
If you suspect that your laser interferes with other equipment, take the following steps to
minimize this interference:
1 Use shielded cables to and from the equipment that is experiencing interference prob-
lems.
2 Ensure that the laser is properly grounded to the same electrical potential as the
equipment or system it is connected to.
FCC caution to the user
The Federal Communications Commission warns the user that changes or modifications of
the unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
6 4
Note: The following FCC information to the user is provided to comply with the requirements
of 47 CFR,
§
18,
§§
213.