Synrad FH FLYER, Operator'S Manual

Page: 41 / 250

getting started
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
4 1
Mounting
Laser
To mount the laser, refer to Figure 1-7 and perform the following steps:
Note: The laser’s mounting feet are precisely aligned at the factory to ensure alignment between the FH
Flyer head and the Mounting Rail. Do not loosen, adjust, or remove the laser’s mounting feet!
Figure 1-7 Mounting the laser
1 Orient the laser on the Mounting Rail with the output aperture facing the L-bracket.
2 Ease the laser forward against the Beam Enclosure Tube until the dowel pins on the mounting feet
drop into the dowel pin holes drilled into the Mounting Rail. The screw holes on the ends of the feet
should be positioned over the appropriate mounting holes as shown in the mounting diagrams in the
Technical Reference chapter. A Firestar t60 laser is shown in Figure 1-7.
3 Install and tighten four capscrews to secure the laser to the Mounting Rail.
48-1/48-2 lasers use 6–32 × 1" socket head capscrews (SHCS).
48-5 lasers use 10–32 × 3/4" SHCS.
Evolution 100/125 lasers use 1/4–20 × 1" SHCS.
Firestar v20/v40 lasers use 1/4–20 × 7/8" SHCS.
Firestar t60/t80/t100 lasers use 1/4–20 × 1" SHCS.
Firestar f100 lasers use 1/4–20 × 1 5/8", 1 3/4", or 2" SHCS (depending on mounting foot height).
4 Verify that the beveled end of the Beam Enclosure Tube is seated in the laser’s beveled aperture open-
ing and then tighten the four button socket screws that fasten the tube to the L-bracket.
5 Connect water, power, and control hookups according to instructions in the laser’s Operator’s
Manual.
ETHERNET
USB
LASER
CONTROL
POWER
USER INTERFACE
TEST
MARK
STATUS
PWR
FH
MARKING HEAD
FLYER