SYMPTOM
The power will not
turn on.
The computer hangs
up at startup.
The PC card cannot
be recognized.
CAUSE
The power is not
connected to an outlet
or computer.
Non-standard SCSI
cable issued.
The SCSI cable is too
long.
The settings for the
SCSI board are not
appropriate.
Loose connection at
the SCSI connector.
The terminator is not
activated.
The same SCSI ID is
assigned to another
SCSI device.
A terminator is
included in another
hard disk in a daisy
chain connection.
EZ-SCSI is not
installed.
ASPIDISK is not
installed.
The card is not
properly inserted.
CORRECTIVE MEASURE
Insert the power plug securely in an
outlet or computer.
Use a standard SCSI cable.
Use a standard SCSI cable(6m or less
in length).
Revise the settings according to the
SCSI board manual.
Plug in the SCSI connector again.
Activate the terminator.
Power off all the devices then change
the SCSI ID.
Remove the terminator or deactivate
the terminator on the PCM-CR-S2I.
Install EZ-SCSI according to the EZ-
SCSI manual. Check the
CONFIG.SYS file for the proper
setting.
Install ASPIDISK included in the
attached floppy disk.
Insert the card properly.
26
Tech Support Line: 213.368.3760
Tech Support Hours: 9am to 5pm, Monday through Friday Pacific Standard Time
email: [email protected]
