22
External Reader Installation
1. Follow the directions above to set up your SCSI interface card unless you
have already done so previously.
2. Close all applications, exit Windows to return to the command prompt (or
shutdown Windows 95), and turn off the system.
3. Connect the reader to the SCSI bus. Normally, the PCM-CR-S2I will be
the last device connected and its terminator must then be set to ON
(default).
4. Set the SCSI ID number in the back of the device to a number between 0
and 6. Be careful not to set it to a number already in use by another SCSI
device. If this is your only SCSI device including internal SCSI hard
disks, then any number will work.
5. Turn on the power to the reader and any other needed external devices.
6. Turn on the computer and boot to Windows.
7. Insert the PC card to be accessed.
NOTE: Make sure everything is connected properly, the terminator is in the correct
position, and the SCSI ID is set to a number not currently in use by the system.
Internal Reader Installation
1. Follow the directions above to set up your SCSI interface card unless
youhave already done so previously.
2. Close all applications, exit Windows to return to the command prompt(or
shutdown Windows), and turn off the system.
3. Set the SCSI ID number as shown later in this manual. Make sure thatthe
SCSI ID number is not already in use by another SCSI device.
4. Connect the reader to the inside of your computer.
5. Turn on the computer and boot to Windows.
6. Insert the PC card to be accessed.
