5-89
Parameter Menus
Beep on <BEL>
When this parameter is enabled, the scanner beeps when a <BEL> character is detected on the
RS-232C serial line. <BEL> is issued to gain a user's attention to indicate an illegal entry or
other important event.
BEEP ON <BEL> CHARACTER
(ENABLE)
DO NOT BEEP ON <BEL> CHARACTER
(DISABLE)
Intercharacter Delay
Select the intercharacter delay option matching host requirements. The intercharacter delay
gives the host system time to service its receiver and perform other tasks between characters.
The delay period can range from no delay to 99 ms in 1 ms increments (if you are using a
cradle and RTS/CTS handshaking, the delay period can range from 5 ms to 99 ms). After
scanning the bar code below, scan two bar codes beginning on page
5-90
to set the desired
time-out. If you make an error, or wish to change your selection, scan CANCEL on page
5-92
.
IINTERCHARACTER DELAY
