Symantec 10521148 - Network Security 7161, Implementation Manual

Page: 158 / 214

150 Maintaining and administering the 7100 Series
Restarting, rebooting, and powering off
Starting Network Security from the LCD
This section describes the procedure for using the LCD panel to start Symantec
Network Security on the node.
To start Symantec Network Security from the LCD
1 On the appliance front panel, press any button to change the LCD display.
If the LCD screen is locked, see
“Unlocking the LCD panel” on page 155 to
unlock it.
2 Press any button to display the LCD run menu unless it is already displayed
on the LCD screen.
3 Use the down arrow button to scroll through the menu until you see:
SNS7120
4. Start SNS
where 7120 is replaced by 7160 or 7161 depending on the model.
4 Press e to start Symantec Network Security.
Starting Network Security from the serial console
This section describes the procedures for using the serial console to start the
Network Security application.
To start Symantec Network Security from the serial console
1 Connect your laptop or other serial device to the appliance with the serial
console cable.
2
Using a serial terminal application, login to the appliance as
secadm
.
3 Type the command:
start
Restarting Network Security from the Network Security
console
This section describes the procedure for restarting Symantec Network Security
from the Network Security console.
To restart Symantec Network Security from the console
1 On the Devices tab, right-click the node on which to restart Network
Security.
2 In the drop-down menu, click Admin > Restart Symantec Network Security
Application .