Symantec 10521148 - Network Security 7161, Implementation Manual

Page: 157 / 214

149 Maintaining and administering the 7100 Series
Restarting, rebooting, and powering off
The LCD panel may be locked. If so, you must unlock it before you can perform
tasks in the LCD run menu.
These procedures are described in the following sections:
■
Stopping Network Security from the LCD
■
Stopping Network Security from the serial console
■
Starting Network Security from the LCD
■
Starting Network Security from the serial console
■
Restarting Network Security from the Network Security console
■
Restarting Network Security from the serial console
Stopping Network Security from the LCD
This section describes the procedure for using the LCD panel to stop Symantec
Network Security on the node.
To stop Symantec Network Security from the LCD
1 On the appliance front panel, press any button to change the LCD display.
If the LCD screen is locked, see
“Unlocking the LCD panel” on page 155 to
unlock it.
2 Press any button to display the LCD run menu unless it is already displayed
on the LCD screen.
3 Use the down arrow button to scroll through the menu until you see:
SNS7120
3. Stop SNS
where 7120 is replaced by 7160 or 7161 depending on the model.
4 Press e to stop Symantec Network Security.
Stopping Network Security from the serial console
This section describes the procedures for using the serial console to stop the
Network Security application.
To stop Symantec Network Security from the serial console
1 Connect your laptop or other serial device to the appliance with the serial
console cable.
2 Using a serial terminal application, login to the appliance as
secadm
.
3 Type the command:
stop