General use
Page 40/52
Installation, commissioning and operating instructions
SYCLOPE
TERE’O Touch
®
CU/PT
g)
Test Mode
Pressing the « Test Mode » button opens the programming window.
➢
Activating relays :
It is possible to activate the relays one by one and to force their state to test the
wiring, to do this simply press the corresponding relay button.
Inactive relay
Active relay
➢
Modem test :
Depending on the presence or absence of a Modem (GSM, Ethernet, WIFI), it is
possible to know the status and type of modem installed.
➢
GSM Modem :
▪
PIN code messages
•
Searching
…
:
Waiting for the Modem module answer.
•
Error :
No answer from the modem, check the hardware connection of the module.
•
PIN requested :
A PIN is needed.
•
PUK requested :
A PUK is needed.
•
PIN2 requested :
A PIN2 is needed.
•
PUK2 requested :
A PUK2 is needed.
•
OK :
Correct answer expected by the system.
The SIM card must not have a programmed PIN. In case of error message of the type "code
required" please disable the code of your card.
▪
Network status messages
•
Searching
…
:
Waiting for the Modem module answer.
•
Error :
No answer from the modem, check the hardware connection of the module.
•
Refuse :
Network access problem, check your APN and contact the SIM card
provider.
•
Connected :
Correct answer expected by the system.
Test Mode
pH relay
Chlorine relay
Timer relay
Activating relays
Test
MODEM
No modem
program