General use
Page 34/52
Installation, commissioning and operating instructions
SYCLOPE
TERE’O Touch
®
CU/PT
➢
Change the flow contact :
If you are using a water flow-switch contact, you must select the operating mode by
pressing the desired mode (Normally Open - Normally Closed).
If the contact is active you can then enter its activation delay (delay take in account
when is state change).
➢
Change the contact activation delay :
Press the button to open the numeric entry keypad.
➢
Change the relay configuration :
If you want to use the third relay output either alarm or timer you have to select the
desired mode.
In the timer version, a timer adjustment button appears to access the relay's time
setting.
➢
Timer screen :
➢
One timer for the entire week :
By checking this box you can then program three timers that will happen every day of
the week.
➢
Day of the week selection :
If you use different timers depending on the days of the week, you have to select day
after day and set for each day the start and end times.
➢
Hours setting :
If you use different timers depending on the days of the week, you have to select day
after day and set for each day the start and end times.
When the entry is invalid the time slot is displayed in red
When the entry is valid the time slot is displayed in green
Timer
Timer
One timer for the entire week
Mon. Tue. Wed. Thu. Fri. Sat. Sun.
Start time
End time
00 : 00
00 : 00
00 : 00
00 : 00
00 : 00
00 : 00
08 : 00
00 : 00
08 : 00
12 : 00