Swissvoice Eurit 535, User Manual, Page: 16 / 102

203245631en_ba_b0
12
Setting up the telephone and putting it into service
Connecting the base station
Warning:
Make sure you do not confuse the plugs
of the telephone line cable and the plug-in
power supply cord on the base station.
• If you do connect the plugs the wrong
way round, the base station will not
function and may be damaged.
Telephone line cable
The telephone line cable has two different
plugs:
1.
Insert the smaller plug into the
socket (telephone icon) underneath
your telephone until the plug snaps
firmly into place.
2. Feed the cord through the moulded
cable duct provided.
3. Connect the larger plug to your
telephone socket.
Power supply cable
1. Insert the plug of the power supply
cable into the socket marked with
the power supply icon until the
plug clicks into place.
2. Feed the cable through the cable
duct provided.
3. Connect the plug-in power supply
to a 230V outlet.
Note:
Your telephone will not function if the
power supply is not plugged in or if the
power fails.
The telephone may only be used in
conjunction with a power supply SNG 5 af
as supplied, which has been tested in
compliance with EN60950 Protection
Class 2.
Base station
Disconnecting the cables from
the base station
1. First unplug the power supply from
the 230V mains socket.
2. To release the plugs, press the
snap-in clip towards the plug body
(e.g. using a small screwdriver) and
at the same time pull the plug out
by the cable.
Power supply cable
(electricity)
Line cable
(telephone)