Fitted equipment
90
WarnInG: use upper bunks for sleeping
only, with the provided protection against
fall out in position
WarnInG: care shall be taken against the
risk of fall out when the upper bunks are in
used by children especially under 6 years
of age, these bunks are not suitable for
use by infants without supervision .
rastrollo blInds (seItz)
blinds and Flyscreens
Flyscreen and blinds operate in the same
manner. The flyscreen can only be ‘fully up’
or ‘fully’ down, but the blind also has an
intermediate position.
To operate, pull down by holding the
fingergrip(s), gently ease towards the window to
locate the catches. To retract, pull down easing
away from the window to release the catches
and guide to the required position.
• Only operate by holding the fingergrip(s)
- pulling on one side will cause uneven
running and snagging.
• Do not allow the blind or flyscreen to re-coil
without control.
• It is not recommended that blinds and/or
flyscreens are left in the down position for
long periods or when travelling, as this can
result in fatigue of the spring.
• Clean the cassette, side track and fabrics
with mild detergent and water.
• Lubrication of mechanism or spring is not
required or recommended. However, if
components should require cleaning, use
only Ambersil 40+ or similar with fluff-
free cloth. Other lubricants may result in
damage to fabrics and plastics.
tension adjustment
Remove plastic cover (if fitted) to locate tension
lugs. The tension lugs have a slot and are
located in the cassette on a ‘bayonet’ principle.
Insert screwdriver into slot (ensure a good fit),
turn lug clockwise to allow the spring tension
to push the lugs just free of the cassette. Keep
fingers away from screwdriver tip to avoid
accidental injury. Spring can now have more or
less tension applied as required.
If in doubt of tension to be applied, release all
tension and re-start. In which case, with blind
fully wound on the roller, apply 12 revolutions of
lug (factory setting).
Refitting is a reversal of removal procedure.
For more detailed information, see
manufacturer’s instructions.
cassette blind and Flyscreen
Always hold the end rod in the middle. When
closing blinds, slide the end rod of the flyscreen
blind on to the end rod of the sun blind and
engage. To open the blind push the end rods
towards the darkening blind to the edge and
disengage the end rods. Now move the end
rod of the flyscreen back by hand - do not let
it recoil.
