Maintenance
115
Recommended lubricant. General purpose
grease to DIN 51825 KTA 3KA.
servicing and care of hot dip
galvanised parts
The formation of white rust is only a surface
coating and has no adverse effect on the anti-
corrosion properties of galvanising. In order to
minimise the potential for the formation of white
rust the following precautions should be taken:
- Ensure there is adequate air circulation
when storing hot dip-galvanised parts.
- After winter journeys it is recommended
that surfaces are washed with clean water.
spare parts
Spare parts are safety critical parts! For this
reason when fitting spare parts in our products
we recommend the use of original AL-KO parts
or those parts that we have explicitly approved.
The reliability, safety and suitability of parts
designed especially for our products, has been
determined using a special test procedure. In
spite of constantly monitoring the market we are
unable to assess or vouch for other products.
If repair work or servicing is required, AL-
KO have a large network of AL-KO service
stations throughout Europe. To establish the
correct spare parts required you should always
quote the model and type of overrun device
in question along with the ETI No. which is
stamped into the overrun device housing. The
ETI number for the Euro Overrun can be found
on the handbrake lever (See Fig. 45).
For Troubleshooting and Fault Finding, please
see Table 3 on Page 116.
