Fitted equipment
83
Important Warning notice! If your toilet
has its own flush-water tank, please make
sure that you do not travel with a flush-
water tank that is too full . do not travel
with water in the toilet bowl . Failure to
adhere to this notice may result in water
damage to your caravan or motor home .
using the toilet with optional features
13. Electric Blade: Push the electric blade
button on the control display to electrically
open or close the blade. In the case of
failure, you can manually open or close the
blade by sliding the small handle under the
toilet bowl sideways.
14. Automatic Ventilator: The ventilator
automatically starts when the control panel is
activated (by pressing the flush button) and
will automatically shut off after approximately
5 minutes. The Automatic Ventilator Indicator
will flash until automatic shut-off occurs. If
you want to stop the ventilator, press the
Automatic Ventilator button. If you want to
re-start the ventilator, press the button again
(the LED will start flashing again).
15. Flush Water Tank Level Indicator (only for
toilets with own flush-water tank): When
the Flush Water Tank Level Indicator lights
up, refill the flush-water tank, as only about
1.5 litres of water is left in the tank, which is
sufficient for approximately 2 flushes.
emptying
The Waste Holding Tank has a capacity of 18
litres and requires emptying when the red light
(LED) on the toilet control display lights up, when
the Waste Holding Tank only has capacity for
approximately 2 more litres, which is no more
than two to three further uses. Make sure that
the blade is closed. Open the access door
located outside the vehicle, pull the safety catch
upwards and remove the Waste Holding Tank.
16. Place the Waste Holding Tank in an upright
position (Pull-Out Handle at the top, Wheels
at the bottom). Slide the handle sideways -
to the front of the tank - until it snaps out of
its locked position.
17. Pull the handle up and wheel the Waste
Holding Tank to an authorised waste
disposal point.
18. Push the handle back into its locked position.
Turn the emptying spout upwards and
remove the cap from the spout. Hold the
Waste Holding Tank in such a way that during
emptying you can operate the vent plunger
with your thumb. To empty the tank without
splashing, depress the vent plunger while
emptying the tank. After emptying, rinse the
tank and blade thoroughly with water.
Warning! do not seriously shake the tank
or use high pressure water cleaners . this
may cause damage to the tank’s interior .
note . the vent plunger should only be
depressed once the emptying spout is
pointing downwards . prepare the toilet
for re-use if required . slide the Waste
Holding tank into the toilet and close
the access door .
emptying with optional features
19. Waste Holding Tank Multi-Level Indicator:
The lower lamp indicates that the Waste
Holding Tank is almost empty; the middle
lamp indicates that it is more than half full;
when the upper lamp lights up, the tank
needs emptying as it can only take 2 - 3
further uses.
note . the Waste Holding tank level
Indicator will flash when the holding tank
is not present . In this case the toilet will
not flush .
20. Waste Pump-Out System: When activating
the control panel this feature automatically
lights up. When the Waste Holding Tank
Level Indicator illuminates, press the Waste
Pump-Out button to pump out the waste
from the holding tank Into the vehicle’s
waste tank. The button will flash while
the waste is being pumped and will stop
automatically (after approximately 5 minutes)
when all waste has been transferred.
