113
HENM-70
Encoder & DVB-S2/S Modulator
USER’S MANUAL V5.6
Chapter 6: Equipment Installation
6.1
Introduction
This chapter provides important information for the transmitter system
installation such as connections available in the rear and front panel of the
HENM-70 and their pinout, connectors needed and the accessories which
are available with the device.
6.2
Connections
Every connection of the HENM-70 encoder and modulator is on the rear
panel.
All the Lemo part numbers and pinout refer to the connector that is fixed to
the cable. The pinout of the cable connector is shown as if it is watched
from the soldering side.
All the input/output connections of the HENM-70 equipment are shown in
the figure below:
Figure 6.1 HENM-70 Connections
The following figures show the HENM-70 front and rear panel. Connections
mentioned in the upper figure are shown below.
Figure 6.2 HENM-70 front panel
HENM-70
Encoder
&
Modulator
SDI (3G/SD/HD)
HDMI
Ethernet
Audio 1 (L&R)
Audio 2 (L&R)
Power AC
I.F. OUT (L-BAND)
Power DC
USB
DATA/GPS
ASI
AES/ABU
TS over IP OUT
TS over IP IN
ASI IN
CVBS
70 MHz
