4/30
ALFA IN a.s ©
www.alfain.eu
2. SAFETY
GENERAL REQUIREMENTS
1. The machine may only be operated by a worker who is thoroughly familiar
with the issue of plasma cutting and who has received appropriate training.
2. Disconnect the device from the mains before any work on the electrical
part, removal of the cover or cleaning.
3. For the cutting machine, it is necessary to perform a periodic inspection
once every six months by an authorized worker according to ČSN 331500
and ČSN 050630.
4. For safety reasons, protective gloves must be worn when plasma cutting
These gloves protect you from heat radiation and splashes of hot metal.
5. Wear solid insulated shoes. Open shoes are not suitable as drops of hot
metal can cause burns.
6. Do not look into the cutting arc without face and eye protection. Always
use a high-quality welding helmet with an intact protective filter.
7. Persons in the vicinity of the cutting site must also be informed of the
danger and must be provided with protective equipment.
8. When cutting, especially in small spaces, a sufficient supply of fresh air
must be ensured, as harmful fumes are produced during cutting.
9. Do not perform cutting work on gas, oil, fuel, etc. tanks (even empty ones)
as there is a risk of explosion.
10. Special regulations apply in potentially explosive atmospheres.
PROTECTIVE EQUIPMENT
1. Welding helmet with filter shade at least 10
2. Welding gloves
3. Welding apron and cloth
4. Welding boots
RISKS - OVERVIEW
1. Risk of electric shock
2. Ultraviolet light and light radiation
3. Risk of inhaling gas fumes and dust particles
4. Burns
5. Noise
Note
Danger of electric shock, especially if the insulation of the torch, the
supply cable fails and if the machine covers are damaged. be aware that the
torch can have a voltage of up to 330 volts.
The parameters of the torch comply with the ČSN EN 60974-7 standard, voltage
class M.
