8/30
ALFA IN a.s ©
www.alfain.eu
Standards
EN 60974-1, EN 60974-10 cl. A
Dimensions (w x l x h)
mm
377 x 802 x 621
Weight
kg
46,7
* Parameters in parentheses are for 32 A mains protection. The machine is
equipped from the factory with a 63 A plug, if you need cutting at DZ 100% with
a current greater than 95 A, it is necessary to replace the fork with 32 A and
operate the machine under a 32 A @ circuit breaker. For normal manual cutting
and most CNC cutting a 32 A plug under a 32 A @ circuit breaker is sufficient in
most cases.
The fork may only be replaced by a person with electrical qualification which
checks the network status at the connection point and decides, if it will be
possible to connect the machine in this way.
DZ – load time. The parameter specifies the time of the ten-minute interval as a
percentage (at surrounding temperature and machine temperature 40
o
C), during
which the thermal protection of the machine or the circuit breaker does not switch
off the cutting process.
CUTTING PARAMETERS OF MACHINE CUTTING
Max. pierce (mild steel)
mm
22
Max. possible cut - separation (mild steel)
mm
50
Cutting speed (mild steel)
Thickness
Max. speed*
Productive cut*
High cut quality*
6 mm
5,6 m/min
5,09 m/min
4,14 m/min
12 mm
2,4 m/min
2,06 m/min
1,69 m/min
20 mm
1,3 m/min
0,94 m/min
0,78 m/min
25 mm
0,8 m/min
0,58 m/min
0,55 m/min
32 mm
0,5 m/min
0,37 m/min
0,35 m/min
* The parameters were measured in test conditions on ALFATEC CNC tables,
they do not necessarily have to be maximum values.
TRAFFIC ON POWER GENERATOR
Cutting current
Performance of power gen.
105 A
39 kVA
85 A
26 kVA
70 A
20 kVA
40 A
16 kVA
30 A
11 kVA
