114
SVANTEK 977W User Manual
SVAN 977W
is delivered with 4GB micro SD-card.
The user may exchange it with the high capacity card (up to 32GB), but before insertion the card must be
formatted as FAT32.
Note: If the user would like to use card with higher capacity, he must call to the local distributer.
To extract the memory card from the card-
slot, the user should switch off the
instrument, unscrew the bolt and take off the
black bottom cover of the instrument.
The card is installed in the slot. To extract
the card the user should push on the card
and then pull it out of the slot.
While insertion the SD-card, a click sound indicates that the card is inserted properly. If necessary, use a tool
(e.g. pen) to push the card right in.
14.3. Transducers
SVAN 977W
is equipped with the TNC
connector as an input of the measured
signal
taken
from
the
microphone
preamplifier or the vibration transducer.
Microphone
SVAN 977W
set includes prepolarised
½”
microphone
with
nominal
sensitivity
35 mV/Pa (
SV 7052
) and microphone
preamplifier with IEPE power supply
(
SV 12L
).
To connect the preamplifier with the
microphone to the instrument the user
should first insert the tip of the preamplifier
into the socket and tighten the ring to the first
screw thread.
Then slide the upper sleeve of the
preamplifier to the instrument and tighten it
on the thicker screw thread.
Note: Do not disconnect the preamplifier by turning the preamplifier body (turn only rings/collars)
because it may damage the preamplifier!
