14-6 FRONT AND REAR WHEELS
REAR WHEEL BEARING REMOVAL
• Remove the dust seals and snap ring from the wheel hub.
• Fit the bearing remover into the wheel bearing.
09921-20220: Bearing remover set
• Remove the bearings and spacer.
REAR WHEEL BEARING REASSEMBLY
• Apply grease to the bearings.
• Reassemble the spacer and bearings with the special tool.
09941-34513: Bearing installer set
NOTE:
After reassembling the bearings, inspect the bearings for
smooth movement.
• Install the snap ring
1
at the left side (sprocket side).
• Install the dust seals and apply grease to its lips.
NOTE:
* The sealed cover of the bearing must face outside.
* Reassemble the left side (sprocket side) bearing first and then
reassemble the right side bearing.
REAR WHEEL INSTALLATION
• Reassemble the rear wheel and axle shaft.
• Adjust the drive chain slack. (
2-13)
• Tighten the axle nut
1
to the specified torque.
Rear axle nut: 72 N·m (7.2 kgf-m, 52.0 lb-ft)
Left
Right
Clearance
Left
Right
Summary of Contents for RM85
